Integrity problem using the spanning feature

[qfire]

Hi,

I have a package done up by Setup Factory 6.0 with a file size of 730MB. I had performed spanning using 650MB and resulted in Setup.exe(Disk1) and setup.2(Disk2) Just to test it out before burn to disk, I have deliberately executed the setup.exe on a windows machine immediately it triggers this error message.

Archive integrity check failed.
The expected setup file size is: 735,211,454 bytes
The actual setup file size is: 650,000,000 bytes
Setup aborted.

I kinda stuck here and couldn't proceed, hope to someone could advise me.

Thank you.

[csd214]

If you have checked ‘Verify archive before installing’ (General Design | Settings):

Uncheck it.

It isn’t possible to combine ‘Verify archive’ with the spanning feature.

[qfire]

Thanks for the advise, it works now.