Include full command line when shelling to 3rd party utils

[jassing]

when shelling to lzma or upx, and an error occurs, please include the full command line that generated the error in the log file as well as the actual exit/error code.

This is not helpful at all (And yes; the file exists, and yes; it previously built fine)

Along these lines, it would be nice to be able to tweak command lines -- as the 3rd party utils typical mature faster than SUF; it would be nice to be able to use them in a more configurable manor.

Build failed.

--------- Errors ---------

LZMA  4.60 beta  Copyright (c) 1999-2008 Igor Pavlov  2008-08-19

Error: Incorrect command


Usage:  LZMA <e|d> inputFile outputFile [<switches>...]
  e: encode file
  d: decode file
  b: Benchmark
<Switches>
  -a{N}:  set compression mode - [0, 1], default: 1 (max)
  -d{N}:  set dictionary - [12, 30], default: 23 (8MB)
  -fb{N}: set number of fast bytes - [5, 273], default: 128
  -mc{N}: set number of cycles for match finder
  -lc{N}: set number of literal context bits - [0, 8], default: 3
  -lp{N}: set number of literal pos bits - [0, 4], default: 0
  -pb{N}: set number of pos bits - [0, 4], default: 2
  -mf{MF_ID}: set Match Finder: [bt2, bt3, bt4, hc4], default: bt4
  -mt{N}: set number of CPU threads
  -eos:   write End Of Stream marker
  -si:    read data from stdin
  -so:    write data to stdout

Error

Error 2091: Could not compress file using LZMA: V:\source\Dev\Common\modules\Support Wizard\Source\..\..\..\..\..\release\ESQL2007\Drivers\Drivers common\reg2.exe
--------------------------

[Darryl]

Thanks for the suggestion.

REF: 18353