|
#1
09-10-2007
|
|||
|
|||
|
Automatic build
Is there a way to run a Publish-Build from a command prompt or CMD file?
For example, if I have an action to run an installer, and the installer itself has been updated, but the Autorun menus are unchanged, what's the best way to rebuild the Hard Drive Folder in an automated build process? Thanks. 
|
|
#2
09-11-2007
|
||||
|
||||
|
Michael,
There are no automated build options in Autorun MAX. If the filename does not change then there is no need to rebuild the project. You could have your automated build simply replace that file in your folder structure. Adam Kapilik
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Unattended Build disabled in Demo version? | Biggles | Setup Factory 7.0 Discussion | 1 | 08-18-2006 03:56 PM |
| Automatic Build? | abc | Setup Factory 6.0 | 6 | 04-17-2003 02:36 PM |
| HOWTO: Build and Burn Your AutoPlay Application | Support | AutoPlay Media Studio 4.0 Examples | 0 | 10-28-2002 04:43 PM |
| HOWTO: Build a Setup from the Command Line | Support | Setup Factory 5.0 | 0 | 10-08-2002 02:43 PM |
| HOWTO: Build a Setup from the Command Line | Support | Setup Factory 6.0 Knowledge Base | 0 | 09-27-2002 03:16 PM |
All times are GMT -6. The time now is 05:37 AM.
