|
#1
08-23-2007
|
||||
|
||||
|
Unable load project after changes
Strange one this. The upgrade project I have been working on is perfect after I change upgrade codes, compile etc until the point SUFWI is shut down. Restart SUFWI either straight away, or even after PC rebooted, then load project again. The hourglass comes up and nothing appears on screen (i.e. no files etc) and after about 60 seconds an 'out of memory' dialogue appears. Any other project loads fine. The only way I can reload this project is to recover from backup (pre-upgrade codes added) and then will load fine everytime unless I insert the upgrade codes, save, shutdown/restart after which it goes belly up again.
I suspect some sort of problem in the XML file saving process. Can I send it in as don't want to post it here? Thanks - John 
|
 |
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Set Up Factory 7.0 is unable to compression my .NET project resource files. | Alphaman5000 | Setup Factory 7.0 Discussion | 2 | 08-05-2007 04:27 AM |
| Saving a Backup Copy of Your Project | Adam | Autorun MAX! 2.0 FAQ | 0 | 08-29-2006 01:51 PM |
| HOWTO: Open a Version 3.0 Project in Version 4.0 | Support | AutoPlay Media Studio 4.0 Examples | 0 | 10-30-2002 03:09 PM |
| HOWTO: Create a Project Template | Support | AutoPlay Media Studio 4.0 Examples | 0 | 10-28-2002 02:49 PM |
| INFO: Recovering a Project File From a Built Application | Support | AutoPlay Media Studio 4.0 Examples | 0 | 10-10-2002 09:44 AM |
All times are GMT -6. The time now is 02:55 AM.
