I'm trying to use the unattended build option and cannot get the values in my ".ini" file to be used within the project. I cannot seem to get SUF to pickup the values from the ".ini" file.
If I code the required values on the "Design time constants" tab then everything is ok. If I remove the values from there then the project builds as if the variables were never coded. If I add the variables on this tab but give them 'dummy' values (hoping the .ini file values will over-ride them) then the project gets built using the 'dummy' values.
I've searched the forum and other people seem to be doing ok, so I'm probably doing something wrong. Any ideas of common mistakes in this area ?
I've checked that I've coded the variable names correctly.
My ".ini" file consists of;
[Constants]
#BUILDNUMBER#=221
#BUILDTYPE#=B
#SETUPPREFIX#=setup
#PUBLICBUILD#=Y
To me this looks to be the same format as the example in the User's guide.
I'm running SUF 6.0.1.2.
Cheers,
Dave
If I code the required values on the "Design time constants" tab then everything is ok. If I remove the values from there then the project builds as if the variables were never coded. If I add the variables on this tab but give them 'dummy' values (hoping the .ini file values will over-ride them) then the project gets built using the 'dummy' values.
I've searched the forum and other people seem to be doing ok, so I'm probably doing something wrong. Any ideas of common mistakes in this area ?
I've checked that I've coded the variable names correctly.
My ".ini" file consists of;
[Constants]
#BUILDNUMBER#=221
#BUILDTYPE#=B
#SETUPPREFIX#=setup
#PUBLICBUILD#=Y
To me this looks to be the same format as the example in the User's guide.
I'm running SUF 6.0.1.2.
Cheers,
Dave
Comment