Installer can't find data section with custom icon

[pico]

When I add custom icon (.ico) with 4-bit, 8-bit and 32-bit images, sizes (16x16 to 256x256), the installer will not start but errors with "can't find data section".

[Mark]

Hi pico,

Are you adding the custom icon under: Project | Advanced Settings: use custom icon or Publish | Settings | Resources: Use custom icon

If so could you please post the icon that you are using? I have tested this on my side and have been unable to replicate this problem so I have a few more questions for you:

1) What operating system are you using?

2) What compression settings are you using?

3) Are you using the commercial or trial version of Setup Factory 8.0?

[JONG]

NVM, I find this is icon file issue.