JXBURNS
03-16-2007, 05:12 AM
Steps to reproduce:
a) Load existing project in which a file has been moved to new location so that line shows in red as missing in ARCHIVE tab.
b) Go to the missing line, and select FILE PROPERTIES.
c) Click BROWSE on LOCAL FOLDER line.
d) Point to new location.
e) The destination changes to %APPFOLDER% (instead of remaining at %SYSTEMFOLDER% which it was).
f) Click CANCEL.
FEATURETTE1: The destination should not change when changing the source.
So cancel out of that and without doing anything else:
1) Repeat steps (b) through (d) above.
2) The system now says "A file already exists with the same path" (path being the newly selected one) however it does not - that is what I trying to change to.
FEATURETTE2: The system appears to be "remembering" what I changed the path to in (d) but in fact I cancelled at (f) and the archive list still shows the original path. The file is only listed once.
Rgds John
a) Load existing project in which a file has been moved to new location so that line shows in red as missing in ARCHIVE tab.
b) Go to the missing line, and select FILE PROPERTIES.
c) Click BROWSE on LOCAL FOLDER line.
d) Point to new location.
e) The destination changes to %APPFOLDER% (instead of remaining at %SYSTEMFOLDER% which it was).
f) Click CANCEL.
FEATURETTE1: The destination should not change when changing the source.
So cancel out of that and without doing anything else:
1) Repeat steps (b) through (d) above.
2) The system now says "A file already exists with the same path" (path being the newly selected one) however it does not - that is what I trying to change to.
FEATURETTE2: The system appears to be "remembering" what I changed the path to in (d) but in fact I cancelled at (f) and the archive list still shows the original path. The file is only listed once.
Rgds John